Oberon Slave Cylinder Blk Lc8
Our Price: £112.51
Product Description:
Oberon Slave Cylinder Blk Lc8 950/990/1050/1090/1190/1290 Clu-0121KTM clutch slave CLU-0121.This Oberon Performance KTM clutch slave cylinder has been designed to improve the efficiency and looks of the original clutch slave cylinder. The internal piston design and seal have been drastically enhanced to prevent leaks and leave a smoother clutch action. CNC machined from 6000 series alloy for lightness, strength and eye-catching looks. Seven fantastic colours to choose from. Everything you need is included in the kit including full instructions and is ready to fit.The piston seals are manufactured from a special rubber which is frozen and then CNC machined with a ‘U’ profile which is specifically for hydraulic use. In addition, the piston itself is guided by a unique piston guide, to prevent wear and maintain correct alignment within the slave unit. This ultimately gives a smoother lever action and prolongs the product’s lifespan. This is a non-serviceable part. Any service or rebuild should be conducted at Oberon’s factory in the UK.Before installing your new purchase please read and understand these instructions fully and make sure you have the required tools at hand, including a suitable catch vessel and some approved clutch fluid which must be used in accordance with the manufacturer’s instructions. Please use only the fluid recommended by your manufacture.Installing the Slave Cylinder: Please read instructions fully before commencing 1. Remove any bodywork or covers (where necessary) to ensure the entire area is easily accessible. The bike will need to be held upright or slightly away from this position to assist the escape of air bubbles. 2. Have a cloth wrapped around the existing clutch body when loosening (but not removing) the hydraulic hose to minimise the spread of fluid. When loosening the hose ensure your catch vessel is in place for any escaping fluid. Remove the existing cylinder from the engine keeping the clutch line and original cylinder together preferably completely wrapped in cloth. 3. This Oberon Performance clutch slave cylinder has been pre-assembled; please ensure the new gasket is fitted prior to fastening the unit to the engine. 4. The pipe and bleed nipple can now be removed from the original cylinder and attached to the new one. Do this as quickly and safely as possible to curb later bleeding times. When refitting the hydraulic hose to the new slave cylinder please use the new sealing washers supplied and ensure all fittings are meticulously clean. 5. Fit the Oberon slave cylinder ensuring all original components are refitted, please note that the master cylinder has a small capacity so careful attention to fluid level is Important. NB, some models require the small chain guard is fitted prior to the hydraulic hose for ease of fitting. Bleed the system through the original bleed valve ensuring a pipe is attached and leading to the catch vessel. Apply approximately six pulls on the clutch lever (holding the lever in on the last stroke). Loosen the valve to release the fluid pressure and retighten before releasing the lever. Repeat this until the clutch no longer feels ‘spongy’. Also ensure the clutch master reservoir levels do not drop low and draw in air. Finally, ensure all fastenings are tightened correctly before starting the engine or using the clutch. You may find it easier and save time, if the new slave cylinder is filled with fluid prior to fitting, by filling the cylinder with the aid of a syringe. WARNINGS DO NOT push against the piston once the cylinder is filled as fluid could be ejected and may cause injury. DO NOT operate the slave cylinder off of the engine, the piston may be ejected - or cause damage to the sea
Model: 60032061344OB
- Manufactured by: Oberon
- In Stock
- New
- Category: Slave Cylinders
0 items
